Resistor for LED indicators (x2) 10W - 10 Ohm

LED turn signal resistor

Resistor LED indicators 10 Watt - 10 Ohm. The pack contains 2 resistors. The series resistor must be connected upstream of each individual turn signal. This means that you'll need a total of 4 pieces.

Conversion to LED indicators

If for some reason you cannot use an LED flasher relay, e.g. if the relay is permanently installed, a resistor is a good alternative. Just like a relay, it controls the current output to bring it into the right range for the LEDs so that the flashing frequency is correct at the end.

Why do you need a relay or a resistor?

The electrical load of LED indicators differs from conventional indicators and the frequency of the flashes is outside the permissible range when using a standard flasher unit. When converting to economical and powerful LED indicators, the correct flashing frequency can only be guaranteed by using a resistor or a special LED flasher unit.

• 10 Watt - 10 Ohm
• Scope of delivery: 2 resistors
• 1x resistor -> 1x blinker!